1. michaeld327's Avatar
    I have an 8330 curve and an Alpine 300BT in my car. When I had the Pearl, it would connect when I started my car. The Curve will not. So each time I have to manually connect and type in the passcode.
    I have tried changing properties but have been unsuccessful.

    Ideas?
    08-12-09 11:09 AM
  2. plunkingtom's Avatar
    Can you tell us what settings you have checked. Once a device is setup you can highlight or select the device, go to device properties to select trusted devices is on.
    08-12-09 11:58 AM
  3. michaeld327's Avatar
    Here are the settings as they are.

    Device Properties:
    Trusted Yes
    Encryption Enabled
    Echo control Automatic

    The phone options are:
    Discoverable Yes
    Allow outgoing calls Always
    Address book transfer All entries
    LED On
    Security level High
    Connect on power up Yes

    Then below all are checked:
    Headset
    Handsfree
    Serial port profile
    Data transfer
    Dial up networking
    Audio source
    A/V Remote control target
    08-12-09 01:27 PM
  4. plunkingtom's Avatar
    Mine is set the same as yours and it works fine. Maybe delete and reinstall the device but try a battery pull first with the phone on.
    08-12-09 03:24 PM
  5. delly44's Avatar
    wow. tried everything to get my bold 9700 to reconnect to Audi MMI. your tip to do a power on battery removal worked !
    many thanks for that suggestion.
    07-02-10 08:28 AM
  6. wiredinontario's Avatar
    most things aren't setup to automatically start from the moment installed or the device is setup...the reboot is usually required to let the device driver load up and do it's stuff
    07-02-10 02:16 PM
LINK TO POST COPIED TO CLIPBOARD