[CrackBerry Question]

On Firday, My STL100-1 runs out of battery and I forgot to charge it. But yesterday, after a day's charge it still failed to boot up and no led light flashes...

Then I tried to connnect it with BB Link, but it also failed. Actually, my compter cannot recognize it. On Friday, I've used the BB Blend, so it should not be the driver problem.

[Carjackd]

Scratch

[likounin]

[Carjackd]

Hang on just noted STL 100

[Carjackd]

STL100-1 variant the volume button reset method doesn't work. In that case, Press and HOLD the Power On Button until you see the BlackBerry LOGO

Posted via my Canadian Passport

[likounin]

I've tried many times, but does not work...

[Uzi]

Hi try download autoloader for your device

Sent from my BlackBerry 10 smartphone on 4G Altel network

[Carjackd]

I've tried many times, but does not work...

Have you ever used an auto loader?

Posted via my Canadian Passport

[likounin]

whats that ? and where to download ?

[Carjackd]

whats that ? and where to download ?

Here is the file for you device . Download it on your PC, and unzip it to your desktop.

I will post the instructions to run it in a moment
https://mega.co.nz/#!61JVgZga!bt7Y6R...ABLTrhtbh6aQE8

[Carjackd]

Here are thorough instructions, it's pretty simple, and will more than likely bring you device back to life


http://forums.crackberry.com/bb10-le...loader-927076/

[likounin]

Thanks, I will try after downloading

[likounin]

It stays at this step...no matter I holding power+V+ or not, still shows USB device cannot be recognized...

[Uzi]

It stays at this step...no matter I holding power+V+ or not, still shows USB device cannot be recognized...

Hi try put out the battery connect to PC and when say connecting to bootroom insert the battery back in
Do it a few times if fail
Good luck

Sent from my BlackBerry 10 smartphone on 4G Altel network

[cbvinh]

I had a Q10 that seemed like it was completely dead - no display, no power light, nothing. I took out the battery and left it alone for 24 hours so that any charge left in the Q10 would discharge. Afterward, I put the battery back in and it booted fine. It's worth a try and less evasive than trying to install the OS again. It'll only takes some patience.

[likounin]

I had a Q10 that seemed like it was completely dead - no display, no power light, nothing. I took out the battery and left it alone for 24 hours so that any charge left in the Q10 would discharge. Afterward, I put the battery back in and it booted fine. It's worth a try and less evasive than trying to install the OS again. It'll only takes some patience.

I will try your method later...

[likounin]

Do you know why it is not recognized by Windows ?

[likounin]

I bought a new battery and still fail to boot up....

[likounin]

Seems I have to say goodbye to BlackBerry..though I loves it.

[cbvinh]

Seems I have to say goodbye to BlackBerry..though I loves it.

Did you try to discharge it for 24 hours without the battery?

[Kaye_max008]

Z10 STL-100 is a mess, the trick is once it fully discharges, you plug the cable onto the computer it will boot up after a minute or so of charging, then instead of charging, it will be discharging even when the cable is connected, hence it goes into that cycle, again and again,

The only way to correct this mess is quickly disconnecting the cable and connect it again, then it will charge, after 13% switch from computer to normal electrical current

Posted via CB10