Z10 rSAP with 10.2.0.810

Hi,
I just installed 10.2.0.810 on a Z10 which works without problems. I was very pleased to see rSAP (bluetooth/configuration) implemented in this new version.
However, coupling the Z10 with my VW Premium handsfree system doesn't work.
What did I do:
- set rSAP enabled
- discovered the phone from the VW system
- entered the connection code
- set the connection type on the Z10 to "my car" (it asks for that during the coupling process)
- now the VW system asks for the PIN of my SIM card. Whatever I entered, the phone disconnects and I had to start over without success.

Was anyone successful in using rSAP with the new release? If so, how? :)

Thanks, Bernhard

I have 10.2.0.810, but have not tried anything more than simple phone pairing with b/t, which worked fine. You might want to post this in the leaks forum instead, you are likely to get more and better help over there.

How come that there is not the same version of software for Q10? as I am unable to connect it to my car :-/

You might want to post this in the leaks forum instead, you are likely to get more and better help over there.

Hello ! ( i'm french, sorry for my "bad english" )
I perhaps found the solution ! :

When the BB is connected, go quickly in the adjustment > repertory > select mem repertory

And Select ONLY SIM contact ( NO Phone contact or SIM/Phone Contact )

Says me if this correct

@+++

Yes this was working... THANK YOU! To quickly select only SIM contacts... Therefore the issue is based on downloading phone contacts... maybe not supporting some letters... Currently I am using only SIM contacts in car :(

That sounds really funky....