By using autoloader i installed 10.3.3 on my Z10,but aftr installation when i checked its settings not showing and even i cant connect to wifi...i tried to downgrade os from 10.3.3 to 10.3.2 but after complete installation its showning blackberry on start up and its struks..is der any way to downgrade os ????
Run the autoloader once again?
You cannot go back to 10.3.2.xxxx. What is your exact OS version? You should get the newest autoloader (10.3.3.2205) for your z10 and try again.
current os version is 10.3.03.2049.
yaa i run it more dan 2 times...but still same. settings cant open,cant connect to internet .
Get yourself a 10.3.2 autoloader and use it to downgrade.
10.3.3 is not compatible with z10 stl100-1 and this is why you should be able to revert back to 10.3.2 using autoloader
If you really have the STL100-1, then 10.3.3.anything would not have even installed. It would have reset itself and rolled back to whatever version it previously had.
10.3.3. Is not compatible with the Z10 -1 hardware. This has been stated all over these forums - especially any thread that had 10.3.3 autoloaders.
Have you re-booted the phone since attempting the update?
Joel
Actually if you use 10.3.3 autoloader on stl100-1, it will install but won't go pas the WiFi setup page.
But if you do a sachesi update on it, it will tell you installed but after rebooting it goes back to the previous OS.
yes i rebooted phone ,but its not working properly,i cant complete set up,wifi not connecting and cant open settings.
Z10STL100-2/10.3.3.2205
Mine.
Posted via CB10
Did u find a solution.stuck with same problem
you can revert back to 10.3.2.680,fixed my phone will fix it for you too
I did try to do it with 2 Z10, Passport and Q10 - nothing happened. How you fix your phone?
Only the STL100-1 model of the Z10 can revert to 10.3.2 because 10.3.3. is not compatible with it and never fully installed.
With any other BB10 phone, once 10.3.3. is loaded, that's it - no going back.
That includes the other 3 Z10 models - the -2, -3 and -4 models.
Good night, I have the same problem, update my blackberry z10 stl100-1 to os 10.3.3 and now I can not complete the configuration. I tried installing blackberry os 10.3.2 but it can not, when I install it only the blackberry logo appears and there it stays. Help
How did you try to reinstall it...via an autoloader ?
10.3.3 did NOT get installed on your Z10STL100-1, because it won't accept it. That is why you can install 10.3.2 again.
Try this autoloader:
https://mega.nz/#!sEYygbzR!xBT2RmPyO...LgT7ZMpbq7-pCE
Link is not working man
Probably because it was a link from 3 years ago.
You will have to ask/beg @conite for the STL100-1 firmware.:)
For Z10STL100-1.
https://mega.nz/file/dJBSmLba#xBT2Rm...LgT7ZMpbq7-pCE