Printable View
Hello guys
today i used my playbook till the entire juice was sucked . And then i kept it on charge and after 3 hours its still zero percentage , it is showing the thunderbolt icon but not charging actually . What should i do . Then i started my playbook and again kept it for charging but its stuck there. I thought that it would be the fault of my charger and then i used the charger of my htc sensation and the result was same . Help me please
There are a number of threads about this. You very likely need to use the "stack charging" method. Search that term.
Ah, I feel your pain, because exactly the same has happened to me. Here is the answer: forums.crackberry.com/blackberry-playbook-f222/quickest-stack-charge-dead-playbook-741383/
The cure is a pain, but it seems to be working for me..
Shut it down and charge it. After a few hours, turn it on with the charger still in and check it again. Are you using the stock charger or a different one?
EDIT: misread your post. Its turning on though? Try a stack charge anyway. I guess.
im using the stock charger and that is what i did.. But that didnt help :(
ROHIT, if you can turn on the playbook, then 'Stack charging' might not be needed. A few months ago, i ran into exactly the same situation. Here is the thread i created. Go through it. It might help you. Good Luck. http://forums.crackberry.com/blackberry-playbook-f222/playbook-battery-0-doesnt-charge-761423/
here's the link to the thread. http://forums.crackberry.com/blackberry-playbook-f222/playbook-battery-0-doesnt-charge-761423/
please can you simplify what has been written in that thread coz im somewhat not getting it...please
Use a power strip with a switch, flip the switch on for however many minutes stack charging says then off for x minutes then on until it kicks in. Leave it charge for a couple hours before touching it.
so brother i should leave it for 4 hours ? Right ?
thats what i did.. You may do a hard reboot while playbook on charger (if playbook turns on). Then leave it for a few more hours. Battery % will surely go up. One thing is certain, there is nothing wrong with your device.. It has happened with many people.
brother now the problem has changed..all juice has been used and now the pb does not start up when i push the start button first the red light blinks followed by the green light a few times and den it shuts down ...when i plug it to a charger a black screen appear which the battery with a thunderbolt through it ...now what should i do ?????
as of now, you should leave it plugged in overnight. Don't use it during that time..
Rohit, you need to call this number if the problem persists - 0008001007985
So, is the problem solved?
i left it on charge last night and yeah now the battery is 82 % and just wanted to ask that will it happen the next i put the pb on charge ?
I didn't get your last question, can you be a bit more specific? Anyway, glad for you that it moved off zero. And it has gone up to 82 %. Thats great.
Now what should you do next? Keep your battery relatively high, say above 30 or 40 percent. Never let it go below 20 % at the very least. For the next few days, playbook battery might charge slowly (this happened with my unit). Slowly, it will get back to normal. If possible, install 'battery guru' app from appworld.
heyy there i have had sort of the same problem but my tablet died but i put my charger in but it will not turn on so i dont know what to do you have any ideas for me because i got it for christmas and it has been brokern for about 4 weeks now :straight-face:
I actually believe your PB has committed suicide as it has probably read all the posts stating it is redundant & abandoned. So sad.
You should still be covered by warranty and also you can try stack charging - info for both to follow:
The PB has a one year warranty to the original purchaser. It also has 90 free Tech support. I do not know how Rim deals with "quasi-tech support v. warranty"
Rim Support
Tel:
Canada Toll Free: 1-877-644-8405
United States Toll Free: 1-877-644-8410
Puerto Rico Toll Free: 1-855-651-4936
Email: [email protected] (this route generally does not work and a call is necessary)
(UK Support) 0800 096 2805
Playbook French Support
Smartphones BlackBerry Z10 - Tous les T�l�phones Portables BlackBerry - FR - France
Phone : 0800 914 533 (within 90 days from activation)
BlackBerry� Customer Support Center
Austria:0800-297-476
Belgium:800-77-980
RIM (Brasil Support toll free number): 0800-022-3161
Bulgaria: 00800-118-1115
Denmark: 802-50198
France: 800-914-533
Germany: 800-181-6530
Italy: 800-789-272
Luxembourg: 800-2-2187
Netherlands: 800-022-7316
Norway: 00-1-647-426-7058
Poland: 00-800-112-43-59
Portugal: 800-827-760
Russia: 8-800-100-9643
South Africa: 0800988892
Spain: 900-866-969
Sweden: 02-079-4448
Switzerland: 0-800-802-492
United Kingdom: 08000962805
Phone-Numbers of BlackBerry PLAYBOOK- Helpdesks...
Germany: 0800 1816530 (Geb�hrenfrei)
North-America: 1 877 255 2377 (Toll Free)
UK: 0808 100 7466 (Toll Free UK only)
Outside UK: +44 1753 558400
Worldwide: 1 519 888 6181
[email protected]
(BTW: Helpdesk for BlackBerry devices -except PlayBook- for Germany:
0180 3302626)
-------
Locked, bricked Stack Charge Charging
More Mapsonburt:
Don't keep trying if you get the Red light/5 Yellows... you'll soon drag the battery down past where you can start it again. Leave it off, plug it in and let it charge (with at least a 1.8A charger). Once you get the flashing (once every few seconds) green light, you can power it up - on the charger. If you do drag it down below the red flash/5 yellows, plug it in for 1 minute, unplug (at the wall) for a second or so, plug it back in and repeat for 20-30 minutes. You'll eventually get the red/yellows and then leave it plugged in (and off) until you get the flashing green. It's a PITA but the PlayBook has a very conservative charging algorithm when the battery is below 2.67 Volts to prevent explosions (I'm guessing). I've never been unable to start one with that method.
Mapsonburt:
The PlayBook OS currently shuts down at 3.5 volts. When the battery gets below 2.67V it won't show power lights or even try to start because there isn't enough juice to even power the processor to run the code on the BIOS. The BIOS is software hard coded on a chip within the PlayBook that tells it how to load the PlayBook OS and is coded such that it only recognizes signed PlayBook boot images (which is why it is so hard to root and that nobody has been able to get one to boot Android or WebOS. The BIOS software also contains some charging algorithms for when the OS is not running - ie device is powered off but plugged into a charging source. This code ONLY runs when the battery is above 2.67 volts because the processor can't run below that.
The root of the problem is that this design issue prevents the device from accepting any charge longer than 60 seconds when the battery is too low to run the charging algorithms on the BIOS or on the OS (one runs before the device is powered on and one runs afterwards). RIM did this because Lithium Ion batteries have a nasty habit of catching fire if not charged properly so they wanted to ensure that the processor could be in control of the charging. Makes perfect sense and they probably thought they were avoiding situations like where early Li Ion batteries on laptops were catching on fire. The problem is they were a bit too aggressive in dealing with the problem at design stage. If the battery is below 2.67Volts their protective algorithms can't run but you also can't put enough charge into the battery to charge it! Hence all the reports of people having success with stack charging.
Unfortunately there are a lot of wrong ways to do this floating around out there and getting repeated everyone someone posts a new thread on the issue. It really should be made a sticky. What is the right way?
1) ONLY use a source that provides 1.7Amps or more of charge. The original charger provides this. The rapid chargers provide a lot more. Your phone charger only provides a fraction of this. Anything less is going to take forever to charge the battery above 2.67 volts and may not have enough juice to charge the battery AT ALL once the processor starts to run above 2.67Volts or even worse once the OS starts to run above 3.5Volts. Forget about using your computer to charge it when the OS isn't running as the computer looks for the hardware to identify itself and won't put out a full charge current unless the device indicates it can accept. Once the OS is running, you'd often CAN get enough power from the USB on the computer but that is because the OS has signaled it is OK for the computer to send it. When the OS/BIOS isn't running, the PlayBook won't take much/any charge from a computer. The rapid chargers are best as they quickly charge but more importantly do not use the (too) flimsy USB port. A lot of problems are caused by this port getting wobbly over time and the device not getting a charge at all. Everyone should have a rapid charger.
2) Until you get your device WELL above the 3.5Volts that let's the PlayBook boot, do NOT try to start it. Every attempt drags the battery down some more and that attempt sucks much more charge from the battery than you can put in in those 60 seconds before the hardware shuts down the charging. How can you tell where your battery is? Well if you are getting no lights on the playbook on your first charging attempt you are below 2.67volts. If lights go on and then it doesn't start the OS it is below 3.5Volts. If it loads the OS and then dies it is just above 3.5Volts. If the device loads the OS it is somewhere below 5.0Volts. Depending upon where you start (how low the battery is) various techniques work best. They are: REAL stack charging (plug in for 60 seconds, unplug, plug in for 60 seconds, repeat until the processor starts accepting charging (the big battery symbol on the screen). Again, DO NOT try to turn the device on until then. You are just working against yourself and it will take much longer. You should get the charging symbol within 20-45 minutes of repeated REAL stack charging. Forget you ever heard of plugging in for 2 mins and then off for 2 mins and similar as those 2 mins of off time are COMPLETELY worthless. I have put a multimeter on the PlayBook in this state and it NEVER takes more than a minute of charge when under 2.67volts but will accept another minute of charge after a short (1-2 second) disconnection. Just do it right.
3) Once you see that charging screen leave it plugged in to the charger (stop stack charging) for at least an hour before you try to start the PlayBook. If you don't you may end up in a situation where the attempt to start drags that battery back down below 2.67V and you have start stack charging again. Be patient, you are almost there!
4) Fully charge your Playbook after this to ensure your PlayBook gets back to 100%.
Unfortunately, there isn't a lot RIM can do about this now. It's a hardware design issue. I'd be interested in knowing if the fixed it with the 4G versions. I don't think I've ever seen that complaint with one of those but I've "fixed" both of mine a few times (the kids keep trying to power them on after letting them shut down on low battery despite me saying time RUN not walk and put it on a rapid charger when ever it hits the flashing red battery signal (9%). I've also helped many friends and people on the web and NOBODY who has followed the instructions has failed to get their PlayBook to charge.
I'm convinced this fault is the reason so many PlayBooks are returned to the stores and through RMA. RIM has been very good about this but it should never have happened. Happy Charging!
........................
The battery is likely below 2.65 volts. That happens if the PlayBook has sat for a while. Plug your charger into the playbook (make sure it's the stock charger and not a computer or other charger as you need to pump in lots of amps - more than 1.7amps - the more the better). The rapid charger is even better as it can go to 5 amps.
LEAVE the charger plugged into your PlayBook. Unplug it from the wall (to save the fragile micro-USB port) every minute for a few seconds and plug back in. You'll see lots of references on the web to plug in for 2 minutes and unplug for 2 minutes. Ignore those. I took the PlayBook apart and put a multimeter on mine when it was doing this. If the battery is below 2.65 volts, the PlayBook charging circuit charges for about 1 minute and then shuts down. NO AMOUNT of continued charging makes any difference. As soon as you unplug it (at the wall) and power it back up, it will take charge again for another 45-60 seconds. Repeat.
Keep doing that for as long as it takes to get the screen to show the charging display. If it is just below 2.65volts, it will take somewhere between 20-45 minutes as the battery only takes a little bit of charge each cycle and you need to get that voltage up over 2.65 volts (at which point it will show the charging display and take a full charge). It may take more... but keep at it. Every time you plug it in for 60 seconds, you are adding a bit more power to the battery.
DO NOT try to power the device on until the device has a full charge. You will just risk getting it into a situation where it can't fully boot before it drags the charge down below 2.65 volts again and you'll have to start all over.
This works... and saves you from having to jump start it like I did the first time I got mine into this situation.
----------------------
KB27705-BlackBerry PlayBook battery power charge, discharge characteristics, and guidance on extending battery life
Hi my playbook is not working my charger is not working:not-interested: can you help me!!!!
Have you tested the charger on a phone? What happened the last time you used it? What happens if you plug in the charger? How old is the unit?