Printable View
Hi guys,
Found my phone like this. Unable to turn on when I woke up the following morning. Tried bb link, didn't work. A lot of people suggest using auto loaders, is this website legit - BlackBerry 10 Autoloaders - BlackBerry Developer , I wasn't doing any security wipe. It's actually frustrating, only have this phone for a couple months and this happened. Any help is greatly appreciated, thanks.
Don't use that site, those autoloaders aren't meant for devices that aren't expressly used for development.
Use these instead: https://forums.crackberry.com/bb10-l...rchive-943672/
10.3.2.2813 should be a good choice, unless you've updated to 10.3.3 already, in which case use 10.3.3.2205.
Tried downloading it, it says zip failed.
What are you extracting it with? And are you downloading to a PC or a phone?
Pc. Is there like a step by step guide?
There is a step by step guide here on CB which you can search for but the procedure is VERY simple. First download the correct autoloader for your device (it should be a zip file), place or download it to your PC desktop. Unzip it with 7zip or Winzip. This should give you a large. Exe file. Next, plug your device into your PC. Close BlackBerry Link if it starts up. Then finally just click the. Exe file and sit back and watch it finish. This should take about 12-15 minutes. Your device will restart and then you can set everything up on a fresh install. Good luck!
Posted via CB10
just play autoloader 10.3.3.2205
Passport SE - SQW-100-4 / 10.3.3.2163
How?
The error code is gone. It's stuck on blackberry logo, doesn't want to load further than that.
Try a hard reset by holding the power button down for about 10 seconds until you see the red led then let go. If it still does not boot up then you may have to reload the OS (autoloader) again. MAKE SURE you have the correct autoloader for your device.
How do I know the correct autoloader?
Reload it twice still no luck. Stuck on blackberry logo.
Since you have a Passport go here: mega:#F!fA0URRLL!P-4nDqc5JWTVRg8fv5LyhA!WM8AHRaK and download the 7zipped 1.46 Gb file for the Passport (3rd file from the top). That is the autoloader. Once you have that file, unzip it using 7zip or winzip and run it as I described in my previous post.
I'm using google drive.
It could stay there for 10-15 minutes sometimes. Don't rush.
I got it to finally work. Thanks a lot guys. I appreciate it.
It's not detecting my sim card. It says unknown network error.
Bbm don't work.
Posted via CB10
When I put my sim card there for some reason it starts heating up.
Posted via CB10
I Had Same problem with my Passport and after downloading the correct file everything is fine again
Thanks to thurask and brookie229 s advice.
Posted via CB10
If I had a PP SE with that error and i'm on 2205 release, which autoloader should I install?
Posted via CB10
2205.
Reload the os again and it's the same thing with the network error.
Same one. 10.3.3.2205.
Thank you, Thurask and Comite. My Passport is alive, again!
Posted via CB10