[jamesand313]

Does anyone know how to do this? It fell out but I found it and put it back into place but I forgot to clean it so now it's dirty inside and my selfie pictures are kind of blurry. Any tips?

[joewoo]

Tiny suction cup?

[FF22]

Does anyone know how to do this? It fell out but I found it and put it back into place but I forgot to clean it so now it's dirty inside and my selfie pictures are kind of blurry. Any tips?

How did you re-attach it? Just pressed it back in place? Or glue/adhesive?

Just gently pry it out if just pressed back in.

Good luck.

[jamesand313]

How did you re-attach it? Just pressed it back in place? Or glue/adhesive?

Just gently pry it out if just pressed back in.

Good luck.

I just pressed it back in. What's a good object to use?I can't get it out gently lol

[anon(4297019)]

I just pressed it back in. What's a good object to use?I can't get it out gently lol

Prying it out is really not an option as it would probably end up nicking the top cover. The whole top cover can be removed fairly easily however and will give you access to the inside of the lens cover.

Start by prying out the plastic piece on the top of the phone, starting at the straight edge(not curved) by using a utility knife to very gently start to pry it up. Once you have it started then just keep prying gently until the plastic piece is off.

Then you'll find 2 little phillips screws (might be covered by a little glue) that hold the top cover on. Remove the screws and then you can lift off the top cover and then you access to the glass.

Or, you could wait for it to fall out again!

[anon(4297019)]

You could also try heat, that would loosen up the glue. Don't use a flame thrower though. Hair dryer on high for a couple of minutes and then tap the phone on a table and it just might fall out.