[tangozulu]

So since my daughter used her honey covered fingers on my Q, I've needed to swap out my keyboard.
I have a new board and a set of cell phone tools but got blocked by the security screws. Where do I buy a tool for removing these without breaking the project bank. My z30 is fine but really missing my keypad.
Thanks

Posted via CB10

[thurask]

AFAIK it uses Torx T2 and T4 screws, so check Amazon/electronics stores for a "cell phone/electronics repair kit". I personally use this one, but you can look for cheaper if you want.

[Jamaa]

Here are the correct sizes you need:

http://forums.crackberry.com/showthread.php?t=1081978


 Q10 SQN100-5/10.3.3.2049 T-Mobile with Wi-Fi calling

[tangozulu]

I have a cell phone kit but the screw to remove the camera cover are the pentalobe which my kit does not have. I have now ordered 2 kits both having the required torques but no pentalobe.

Posted via CB10

[Jamaa]

I have a cell phone kit but the screw to remove the camera cover are the pentalobe which my kit does not have. I have now ordered 2 kits both having the required torques but no pentalobe.

Posted via CB10

Read my post again.

NONE of the screws on these phones is a pentalobe.

The camera screws are T3 torx.

 Q10 SQN100-5/10.3.3.2049 T-Mobile with Wi-Fi calling

[tangozulu]

OK I will,
Thanks for the heads up. I will report back with my q10 hopefully.
Thank you

Posted via CB10

[tangozulu]

Mission accomplished.
Sent by my awesome Q10.
Thanks every one and good night.
tango

Posted via CB10