[HotFix]

I haven't seen any issues since upgrading, but my dad is seeing several.

I upgraded his STL100-3 from the official AT&T 10.1 to 10.2.1.2102 using Sachesi and the official Vodaphone UK release.

Now he is seeing spotty WiFi performance. Also every time he turns his phone on after being off overnight, WiFi is off even though it was on went he turned the phone off.

Anyone see either of these two issues? The only thing I can think to suggest to him is to have him downgrade to the 1926 radio, but that's a shot in the dark from my POV.

Posted via CB10 on a Z10STL100-3/10.2.1.2141

[n8tiveg]

I've had the not coming on every once in awhile before on other leaks but haven't noticed it on 2102. I haven't noticed any wifi issues on my phone though. I do have att as well. But I prefer using the autoloader wipe autoloader way to ota or upgrading via bar files aka sanchesi.

Posted via CB10

[HotFix]

Anyone else seeing WiFi oddities with the new OS?

Posted via CB10 on a Z10STL100-3/10.2.1.2141

[QWKSNKE]

I haven't yet

STL-4. 10.2.1.2141 w/ 1259 clock

[amirnabilkamelsaad]

I've tried using Sachesi several times and I had bad luck more than good...try to remove the wireless connections and add it back up again and see if that helps (although I doubt it)
The second thing is to ask if that wifi issue was chronic to start up with because it might be a faulty device, my wife had a similar issue with her NFC on the same model and carrier.
If you're sure everything fails to fix it, then try the autoloader (yeah, bummer) and try to diagnose from there. I've had issues with restoring applications where my phone's android would act crazy and I have to start all over but, I hate to generalize my problems.
Hope you don't have to resort to that last solution.

[danp2000]

I haven't seen any WiFi issues though i upgraded from 10.2.1.1925 using Sachesi.

I have heard upgrading from a 10.1 build to a 10.2 build can be spotty.

FYI, this was my first time to use Sachesi for an upgrade and it was painless.

T-Mobile Z10, STL100-3, 10.2.1.2141

Posted via CB10

[JNCB]

Performance was definitely spotty for me. My idle drain rate was significantly higher than .1925/1926 as well. Idle rates on .2102 were around 0.2W on the low end up to 0.6W on the higher end. By comparison, I was getting idle drain rates of 0.04-0.08W on .1925/.1926.

One word of caution on downgrading to the .1926 radio. I tried that using an autoloader (after using Sachesi to load .2102) and I bricked my phone. I had to do a full restore. I'm back on .1925/.1926 now. I may try and just load the .2102 OS (and not the radio) using Sachesi.

[I will be back]

I have issue on my Z30
It disables home WiFi every few hours.

Cellular Network goes down quite often.

I'll try hardware reset(2 volume buttons) as helped with one Z10 problem in a past.

[HotFix]

Performance was definitely spotty for me. My idle drain rate was significantly higher than .1925/1926 as well. Idle rates on .2102 were around 0.2W on the low end up to 0.6W on the higher end. By comparison, I was getting idle drain rates of 0.04-0.08W on .1925/.1926.

One word of caution on downgrading to the .1926 radio. I tried that using an autoloader (after using Sachesi to load .2102) and I bricked my phone. I had to do a full restore. I'm back on .1925/.1926 now. I may try and just load the .2102 OS (and not the radio) using Sachesi.

I think I will get my dad to use Sachesi to downgrade the radio via the bar file if w ego that route.

I bricked my phone trying to use the 1926 autoloader as well.

Posted via CB10 on a Z10STL100-3/10.2.1.2141

[HotFix]

I have issue on my Z30
It disables home WiFi every few hours.

Cellular Network goes down quite often.

I'll try hardware reset(2 volume buttons) as helped with one Z10 problem in a past.

I think he is seeing similar issues with his Z10.

Posted via CB10 on a Z10STL100-3/10.2.1.2141

[anon(1852343)]

No issues on my Q using autoloader

Q10 with Telus on 10.2.1.2141

[BruceFlea478]

Yup, every time I reboot the z10 it turns the wifi off. Thank goodness I rarely do that, not a big deal bit I can see it being an issue for those who don't notice it and have a smaller data plan.

Posted via CB10

[I will be back]

Hurrah!
It worked for me.

Try Hardware Reset:
Close all active frames.
Hold <VolumeUp>+<VolumeDown> buttons on the side of the device for 15 to 20 seconds till it reboots.

It did help me.

No WiFi has been disabled or cellular network disconnected since.

[BruceFlea478]

Awesome, hard reset worked for me as well. No wifi issues anymore.

Posted via CB10

[JNCB]

I think I will get my dad to use Sachesi to downgrade the radio via the bar file if w ego that route.

I bricked my phone trying to use the 1926 autoloader as well.

After I bricked my phone I restored to .1925/.1926. I then installed .2141 without the radio file using Sachesi. It ended up keeping the .1926 radio so I now run a hybrid .2141/.1926. Works like a champ. The wifi is back to its normal drain rate and no connectivity issues.

Has the bar file for .1926 shown up? I wasn't able to find it so I had to get creative to use .2141/.1926.

[kfroese]

My wifi is spotty on this build. Weak connection sometimes. Disables perfectly fine wifi. Hard reset hasn't helped.

Q10SQN100-1/10.2.1.2141

[richrockx]

No, just battery life, trying to figure out if it is a side effect of the in place upgrade through sachesi, are people who used full autoloader for. 2141 having good battery life?

Via CB10, Brklyn, NY

[moegh]

What's different in this update? I didn't find anything!!

Posted via CB10 - Q5

[HotFix]

What's different in this update? I didn't find anything!!

Posted via CB10 - Q5

Talk about trying to high jack this thread.... there are plenty of other threads on this including one started by Omnitech as an unofficial change log

Posted via CB10 on a Z10STL100-3/10.2.1.2141

[HotFix]

My dad tried the volume buttons reset and I think things improved for him. I also think his wireless router is acting squirely.

Thanks for all of the great responses.

Posted via CB10 on a Z10STL100-3/10.2.1.2141

[templar1164]

Just got my Z30 today. Loaded 2102 and for a while all was good. But now I'm getting the wifi has limited access try another connection message. But it says connected. However the wifi symbol isn't on where it should be. I've restarted everything. Deleted and redone the connection on my phone. Nothing works. Any ideas. Can't seem to find an answer...


Posted via CB10

[conkybubs]

Seems to be an issue for many just starting tonight

http://forums.crackberry.com/showthread.php?t=909840

Posted via CB10

[2Peks1Bird]

Anyone else seeing WiFi oddities with the new OS?

Posted via CB10 on a Z10STL100-3/10.2.1.2141

Me!


Z10 STL100-2 / Official Release 10.2.1.1925

[templar1164]

So now...I guess I'm using my data. And on VZW that can get expensive

Posted via CB10

[templar1164]

Ok. I tried downgrading to 1926 radio. That didn't help. I'm gonna wipe and reload and see what happens. This is ridiculous


Posted via CB10