awsome! was it hard to change the bezel? did you encounter any problems?, now you are just missing to change the part where it says Rogers and ur good to go
Brave man...nice job...I did many Bold 9000 mods but I'm a little scared to mess with this one looking at the process...looks a little more fragile...what do you think?
Posted from my CrackBerry at wapforums.crackberry.com
That's very nice! But why didn't you just get the OEM black bezel instead?
2 reasons........
1, the OEM black one you can buy isn't flat black, it's gloss, and the last one I bought for the old bold started chipping the gloss black paint off. This way, if I happen to scrath it somehow, then I can give it a quick sand, and it's new again...
2, I can't wait 1-2 weeks for them to mail me one
Originally Posted by ibcop
Looks great although I would have the pucker factor going to do that with a new phone.....how long did it take you?
about 2 hours
Originally Posted by inkwell
OP, popp, what theme are you using?
It's called Precision Modification v1 5_0 (it's in the 8900 theme section)
Originally Posted by LSCUP7187
Brave man...nice job...I did many Bold 9000 mods but I'm a little scared to mess with this one looking at the process...looks a little more fragile...what do you think?
I had my Bold 9000 down to 10 min to fully swap bezels, keyboards, balls etc........ The 9700 is easier. 2 screws and 4 clips.......done.
I have a red frame and battery door coming from Truesupplier. It looks fairly easy to take apart the 9700 to swap frames, although it must be done gently because of the fact that the frame is plastic.