[motzkopf06]

Hi,

Sorry for my bad English. Maybe someone can help me.
I have by a used BlackBerry Q10. An amateur at the SimCardReader has soldered and caused extensive damage.
So I changed the motherboard. Has works great.
If I now start the Q10, a diagnostic screen appears. But nothing more.
How do I get firmware and OS on the device now?
How I can extract the data from the old motherboard and transferred to the new?

Thanks

[xxxmerlinxxx]

I would try loading any of the official or leaked operating systems in autoloader form. You can find the leaked OS autoloaders here:
BB10 Leaked/Beta OS - BlackBerry Forums at CrackBerry.com
The latest leaked OS is 10.3.1.1016

[motzkopf06]

Thank you.
I found this.
But must I not previously Flash firmware, radio, etc? Is it blackberry other than in android?
Is there somewhere a good step by step instructions?

[FCSC]

load os via autoloader:

http://forums.crackberry.com/bb10-le...l#post10989041

data from old motherboard is lost, unless you place that motherboard into a Q10, and then back it up to a computer through blackberry Link.

[Draven2666]

Hi,

Sorry for my bad English. Maybe someone can help me.
I have by a used BlackBerry Q10. An amateur at the SimCardReader has soldered and caused extensive damage.
So I changed the motherboard. Has works great.
If I now start the Q10, a diagnostic screen appears. But nothing more.
How do I get firmware and OS on the device now?
How I can extract the data from the old motherboard and transferred to the new?

Thanks

Where did you buy a new motherboard? I been searching in case mine is dead.

Posted via CB10

[FCSC]

Where did you buy a new motherboard? I been searching in case mine is dead.

Posted via CB10

100% it's from a broken Q10. Broken screen etc.

Posted via CB10

[motzkopf06]

Hello
Thank you for the answers. I answer only now, I was sick.
I'll try this "[Guide] how to load an OS using autoloader"
Can I restore then also the IMEI, is which zero?

I bought the new mainboard on amazon

[motzkopf06]

followed the instructions with the autoloader.
When I connect the Q10 on the PC, it is detected.
The Flash went without errors, all data has been written.
The Q10 was a reboot, then showed the picture of "Blackberry".
But then the screen remained black. The red LED flashes 10111111,
so even blink, blink, pause and then 6 x. More didn't happen.

What can I do now? But, the software fits the Q10, I have checked it several times.
I have a SQN100-3
This version i have download, extract and install: Q10_10. 2.02. 1609_SQN100-1-2-3-4-5.7z

[jpthev]

HI
It happens exactly the same, and I have no idea what to do.
Any advices, they are welcome.
JPh